Access Policy Commands - Allied Telesis AT-9108 Manual

Access Policy Commands

Access Policy Commands
Command
config access-profile <access_profile> add
{vlan <name> | ipaddress <ipaddress>
<subnet_mask>
config access-profile <access_profile> delete
{vlan <name> | ipaddress <ipaddress>
<subnet_mask>
config access-profile <access_profile> mode
[permit | deny]
create access-profile <access_profile> type
[vlan | ipaddress]
delete access-profile <access_profile>
show access-profile <access_profile>
14
Description
Adds an IP address or VLAN name to the access profile. The entry
must be of the same type as the access profile (for example, IP
address).
Deletes an IP address or VLAN name from the access profile.
Configures the access profile to be one of the following:
permit — Allows the addresses that match the access profile
description.
deny — Denies the addresses that match the access profile
description.
The default setting is permit.
Creates an access profile. Once the access profile is created, one or
more addresses can be added to it, and the profile can be used to
control a specific routing protocol
Deletes an access profile.
Displays access-profile related information for the switch.