Vlan Commands - Allied Telesis AT-9108 Manual

VLAN Commands

Command
config dot1p ethertype <ethertype>
config gvrp {listen | send | both | none} {port
<portlist>}
config protocol <protocol_name> [add |
delete] <protocol_type> <hex_value>
{<protocol_type> <hex_value>} ...
config vlan <name> add port <portlist> {tagged
| untagged}
config vlan <name> delete port <portlist>
{tagged | untagged}
config vlan <name> ipaddress <ipaddress>
{<mask>}
config vlan <name> protocol
[<protocol_name> | any]
config vlan <name> qosprofile <qosname>
config vlan <name> tag <vlanid>
create protocol <protocol_name>
create vlan <name>
delete protocol <protocol>
delete vlan <name>
disable gvrp
disable ignore-stp vlan <name>
enable gvrp
AT-9108, AT-8518, AT-8525, and AT-8550 User's Command Guide
Description
Configures an IEEE 802.1Q Ethertype. Use this command only if you
have another switch that supports 802.1Q, but uses a different
Ethertype value than 8100.
Configures the sending and receiving GVRP information one or all a
ports. Options include the following:
listen — Receive GVRP packets.
send — Send GVRP packets.
both — Send and receive GVRP packets.
none — Disable the port from participating in GVRP
operation.
The default setting is both.
Configures a protocol filter. Supported <protocol_type> values
include:
etype
llc
snap
The variable <hex_value> is a hexadecimal number between 0
and FFFF that represents either the Ethernet protocol type (for
EtherType), the DSAP/SSAP combination (for LLC), or the SNAP-
encoded Ethernet protocol type (for SNAP).
Adds one or more ports to a VLAN. You can specify tagged port(s),
untagged port(s). By default, ports are untagged.
Deletes one or more ports from a VLAN.
Assigns an IP address and an optional mask to the VLAN.
Configures a protocol-based VLAN. If the keyword any is specified,
then it becomes the default VLAN. All packets that cannot be
classified into other protocol-based VLANs are assigned to the
default VLAN of that port.
Configures a VLAN to use a particular QoS profile. Dynamic FDB
entries associated with the VLAN are flushed once the change is
committed.
Assigns a numerical VLANid. The valid range is from 1 to 4095.
Creates a user-defined protocol.
Creates a named VLAN.
Removes a protocol.
Removes a VLAN.
Disables the Generic VLAN Registration Protocol (GVRP).
Allows a VLAN to use STP port information.
Enables the Generic VLAN Registration Protocol (GVRP). The default
setting is disabled.
5