Table of Contents
Advertisement
2
LOCATION AND FUNCTION OF CONTROLS
Rear Panel Terminology
1.
Communication port (800 peripherals)
- allows communication between the RCVDS switcher and the projector.
- allows connection of a remote IR receiver unit to the projector.
2.
IR Remote - Remote input for wired remote control
3.
IR sensor
- Receiver for control signals transmitted from the RCU.
4.
RGB-S IN or (R-Y)Y(B-Y)-S IN ( 4 x BNC connector ) :
RGB-S in : allows a character generator, microcomputer, video camera, etc. having analog RGB output to be connected to
the projector.
Line inputs :
- signals RED-GREEN-BLUE
- COMPOSITE sync. signal
5.
VIDEO IN ( Composite video, 1 x BNC) connector allows a video tape recorder, video camera, color receiver/monitor,
etc. having video line output to be connected to the projector.
6.
S-VIDEO IN : Separated Y/C (luma-chroma) signal inputs and outputs for higher quality playback of Super VHS signals.
(4-pin S-VIDEO connector).
7.
Auto diagnosis display
8.
Local key Pad
9.
Power (Mains) Switch: Depending on the software set-up of the projector during installation, the projector switches to
'standby' or to 'operational mode'. If in standby, the standby led in the auto diagnosis display lights up.
10. Power (Mains) input: Connect the supplied ac power (mains) cord here and to the wall outlet.
11. Audio Output : Only if the Tuner option is installed. Audio out to be connected to audio amplifier.
12. RF input : Only if the Tuner option is installed. Input for RF signals from a TV cable network or TV antenna.
13. RS 232 : Allows connection to the serial port of a Computer for controlling the projector. The baud rate is fixed at 9600.
Front Panel Terminology
1.
IR SENSOR : Receiver for control signals transmitted from the RCU.
R5976101.02 BARCO CINE5 310102 ___________________________________________________________________________
1
11
2
3
12
4
7
8
13
5
6
Stand By / Operational
Pause
Sync
Hold Down EHT
IR
1
Locations and Functions of Controls
9
10
2-1
Advertisement
Table of Contents
