Barco R9002411 Owner's Manual page 35

Total Run Time
Highlight Total Run time using the arrow keys and then press ENTER to
display the total time the projector has run since its first start up at the factory.
EXIT returns to the Service Mode menu.
Note : All projectors leave the factory after a burn-in period of
approximately 100 hours.
Change Password
This item is password protected.
'
Highlight CHANGE PASSWORD using the arrow keys and then press ENTER. The current password is displayed. The new
password must consist of 4 digits, 0 to 9. Select the digit to be changed with the arrow keys and use the numeric keys to enter
the new digits.
Press ENTER to save the new password. Before saving, a confirmation screen will be displayed.
Press EXIT to return to the Projector Setup menu without saving the new password.
When the displayed password is correct, press ENTER to save.
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
POWERUP MODE : Standby
COMMON ADDRESS : 0
or
Select with
then <ENTER>
<EXIT> to return
Change Projector Address
Every projector requires an individual address between 0 and 255.
This address can be software installed.
To change the address, use the arrow keys to highlight CHANGE PROJECTOR ADDRESS and then press ENTER.
The Change Projector Address menu will be displayed and the actual current address will be displayed.
The first digit is highlighted. Select the individual digits using the arrow keys. Reprogram with the digit keys on the RCU.
Press ENTER to confirm. Press EXIT to return to the PROJECTOR SETUP menu.
R5976101.02 BARCO CINE5 310102 ___________________________________________________________________________
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
POWERUP MODE : Standby
COMMON ADDRESS
or
Select with
then <ENTER>
<EXIT> to return
If not correct, press EXIT to cancel the saving.
PASSWORD
ENTER NEW PASSWORD
Enter
Password
Use &
**** and reprogram
with numeric keys
<ENTER>to confirm
<EXIT> to calcel
PROJECTOR ADDRESS
Enter new projector address
0 0 0
Use and to select
and reprogram
with numeric keys
Highest address is 255
<ENTER> to confirm
<EXIT> to return
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
POWERUP MODE : Standby
COMMON ADDRESS : 0
or
Select with
then <ENTER>
<EXIT> to return
CHANGE PASSWORD
0 0 0 0
to select,
Password will be
reprogrammed as ...
<ENTER> to confirm
<EXIT> to cancel
CHANGE PROJECTOR
ADDRESS
Projector address will
be to ...
<ENTER> to confirm
<EXIT> to cancel
Service Mode
7-3