Table of Contents
Advertisement
6.10 OPTIONAL CMP30 RAM3 INSTALLATION
The GX2000E/GX2100E is capable of using a CMP30 ( RAM3 ) Remote Sta-
tion Microphone to remotely control the Radio, AIS, DSC and PA/Fog func-
tions. In addition the GX2000E/GX2100E can operate as a full function inter-
com system between the RAM3 and the radio.
1. Connect the Extension Cable to the Remote Mic eight pin connector on
the rear panel, then tighten the Cable Nut (see illustration below).
2. Referring to illustration below, make a 30 mm hole in the wall, then insert
the Extension Cable into this hole. Connect the Gasket and Mount Base to
the Extension Cable Connector using the Nut.
3. Drill the four Screw holes (approx. 2 mm) on the wall, then install the Mount-
ing Base to the wall using four screws.
4. Put the Rubber Cap on to the Nut. The installation is now complete.
The routing cable can be cut and spliced, however care needs to be
taken when reconnecting the wires to ensure water integrity.
Before cutting the cable make sure it is not plugged into the radio. After
cutting you will notice there are the following wires:
Yellow, Green, Brown, Purple, Blue, Green, Red , Shield
The red and shield wires are wrapped in foil. Remove the foil, and
separate the Red and shield wires.
GX2000E/GX2100E
NOTE
Wall
Routing Cable
External Speaker Connections
Gasket
Mounting Bracket
Cap
Nut
Page 25
Advertisement
Table of Contents
