Appendix A: D-Link Unified Access System Default Settings; Default D-Link Unified Switch Settings; Table 85: Switch Defaults - D-Link DWS-3000 Series User Manual

Software User Manual
02/15/2011
Ap pen d ix A : D-L i nk U nifie d Ac ces s Syste m
This chapter identifies the default values for the D-Link Unified Switch, the default D-Link Access Point settings, and the
default AP Profile setting that the switch assigns to the AP after it is discovered and authenticated (when the AP uses the
default profile).
D D-L U
EFAULT INK
Table 85 shows the default settings for the D-Link Unified Switch.
Feature
System Information
User Name
Password
Network Information
DHCP Client
Network Configuration Protocol
IP Address
Subnet Mask
802.1Q
Management VLAN ID
Untagged VLAN ID
Spanning Tree Protocol
WLAN Information
Unified Switch Mode
AP Authentication
AP Validation
Country Code
Default Profile Name
Peer Switch Group ID
L2 (VLAN) /L3 (IP) Discovery
SNMP Traps
Client Roam Timeout
Ad Hoc Client Status
AP Failure Status
Client Failure Status
RF Scan Status
Document 34CS3000-SWUM104-D10
Default Settings
S S
NIFIED WITCH ETTINGS

Table 85: Switch Defaults

D-Link Unified Access System
Default
admin
None
Disabled
None
10.90.90.90
255.0.0.0
Enabled
1
1
Enabled
Enabled
Disabled
Local
US
Default
1
Enabled
Disabled
30 seconds
24 hours
24 hours
24 hours
24 hours
Page 203