Figure 55: Ap Upgrade Status; Table 23: Ap Upgrade Status - D-Link DWS-3000 Series User Manual

Software User Manual
02/15/2011
Field
Managed AP
After you provide the information about the upgrade file, click Start to begin the upgrade process. Additional fields appear
to provide information about upgrade status and success.
Click Refresh to update the screen with the most current information.
The software download could be aborted while the code transfer is in progress for any AP only during the time the Abort
button is displayed. It still completes the download from the TFTP server, but does not update its NVRAM. Once the NVRAM
update begins for all APs involved, the Abort button disappears. An activity/progress bar is displayed during the upgrade.
The activity bar is no longer displayed once the upgrade process is complete, that is, the AP is up and running and managed.
Table 23 describes the fields that appear after you start the AP upgrade process.
Field
Download Status
Document 34CS3000-SWUM104-D10
Table 22: AP Upgrade
Description
The combination box lists the APs that the switch manages. Each AP is identified by its MAC
address and location (if specified). To upgrade one or more APs, select the AP MAC address
from the list. To upgrade all APs, select "All" from the top of the list. The Group Size field limits
the number of simultaneous AP upgrades in order not to overwhelm the TFTP server.
NOTE: We recommend that you upgrade all managed APs at the same time.

Figure 55: AP Upgrade Status.

Table 23: AP Upgrade Status

Description
This field shows the status of the upgrade process for all APs:
• Not Started—The Unified Switch has not started the download process.
• Requested—A request to download AP software has been made, but the switch has not done
any downloads.
• In Progress—The AP is currently attempting to download software from the server.
• Success—Download completed successfully on all APs. An AP reports a successful
download to the switch after the software transfers from the TFTP server to the AP and the
code checksum is good. The code must also match the intended hardware platform.
• Failure—Download failed on all APs. A software download fails if the AP reports a software
download failure due to an inability to contact the TFTP server or find the upgrade file, or if
the AP loses connectivity with the switch.
D-Link Unified Access System
Page 113