Powering On The Switch; Installing The Sfp Ports; Figure 21: Mounting The Switch In A Standard 19" Rack - D-Link DWS-3000 Series User Manual

Software User Manual D-Link Unified Access System
02/15/2011
Fasten the mounting brackets to the Switch using the screws provided. With the brackets attached securely, the Switch can
be mounted in a standard rack as shown in <Link>Figure 21.

Figure 21: Mounting the Switch in a Standard 19" Rack

Powering On the Switch

Plug one end of the AC power cord into the power connector of the Switch and the other end into the local power source
outlet.
After powering on the Switch, the LED indicators will momentarily blink. This blinking of the LED indicators represents a reset
of the system.
Power Failure
As a precaution, in the event of a power failure, unplug the Switch. When power is resumed, plug the Switch back in.

Installing the SFP ports

The DWS-3000 series switches are equipped with SFP (Small Form-factor Pluggable) ports, which are to be used with fiber-
optical transceiver cabling in order to uplink various other networking devices for a gigabit link that may span great distances.
These SFP ports support full-duplex transmissions, have auto-negotiation and can be used with DEM-310GT (1000BASE-
LX), DEM-311GT (1000BASE-SX), DEM-314GT (1000BASE-LH) and DEM-315GT (1000BASE-ZX) transceivers. See the
figure below for installing the SFP ports in the Switch.
Document 34CS3000-SWUM104-D10 Page 45