Performing Advanced Access Point Management; Figure 56: Advanced Ap Management - D-Link DWS-3000 Series User Manual

D-Link Unified Access System
Field
Download Count
Success Count
Failure Count
A table also appears and lists each AP, its download status, and the software version it is downloading. The status for an
individual AP can have one of the following values:
• Requested—Download has been requested for this AP.
• Success—The AP reported successful code download.
• Failure—The AP reported a failed code download.
• Code Transfer In Progress—The code download to the AP is in progress.
• NVRAM Update In Progress—The AP NVRAM is being updated.
• Waiting for APs to Download—The code transfer is complete, but the AP is waiting for the remaining APs to finish
downloading and then it will start updating its NVRAM.
• Aborted—The upgrade of the AP was aborted.

Performing Advanced Access Point Management

When the D-Link Access Point is in Managed mode, remote access to the AP is disabled. However, you can enable Telnet
access by enabling the Debug feature on the AP Management > Advanced page. From the Advanced page, you can also
manually change the RF channel and power for each radio on an AP.
Each AP managed by the D-Link Unified Switch is listed by its MAC address and location. The location is based on the value
in the RADIUS or local Valid AP database.
Page 114
Table 23: AP Upgrade Status
Description
The number in this field shows the number of managed APs to download software in the
current download request. If you selected All for the managed APs to upgrade, the download
count shows the number of managed APs at the time the download request was started. The
value is 1 if only one AP is being updated.
The number in this field shows the number of APs that have successfully downloaded the new
code. This value starts with 0 at the beginning of the download and increases by one for every
AP that successfully downloaded the code.
The number in this field shows the number of APs that failed to download the new code. This
value starts with 0 at the beginning of the download and increases by one for every AP that
failed to downloaded the code.

Figure 56: Advanced AP Management

Table 24 describes the Advanced features you can configure for the AP.
Software User Manual
02/15/2011
Document 34CS3000-SWUM104-D10