Software User Manual
02/15/2011
S e c t i on 1 0 : C o nf i gu r i n g t he C a p t iv e P or ta l
The Captive Portal (CP) feature allows you to block wired and wireless clients from accessing the network until user
verification has been established.
This chapter contains the following sections to help you configure and monitor the CP feature on the Unified Switch.
•
"Configuring Global Captive Portal Settings"
•
"Configuring the Captive Portal"
•
"Monitoring and Configuring Captive Portal Users"
•
"Associating Interfaces with the Captive Portal"
•
"Viewing the Captive Portal Global Status"
•
"Viewing the Client Summary"
•
"SNMP Trap Configuration"
For information about the commands you use to manage and maintain the APs by using the CLI, see the D-Link CLI
Command Reference.
Note: The captive portal configuration pages are available from the Security folder under both the LAN and WLAN
tabs.
Document
34CS3000-SWUM104-D10
Figure 77: Navigating to the Captive Portal Feature
D-Link Unified Access System
Page 165