Configuring Users In The Local Database; Figure 87: Local User Configuration; Table 70: Local User Configuration - D-Link DWS-3000 Series User Manual

D-Link Unified Access System
Field
Idle Timeout
Use the buttons at the bottom of the page to perform the following tasks:
• To access the configuration page for a specific user listed on the page, click the user name.
• To add a new user and configure the Local User settings, click Add.
• To delete a user from the local database, select the check box next to the user to remove and click Delete. Select
multiple check boxes to delete more than one user at a time.
• Click Delete All to remove all configured users from the local database.
• Click Refresh to update the screen with the most current information.

Configuring Users in the Local Database

From the Local User Configuration page, you can configure additional settings for an existing CP user in the local
database.
Table 70 describes the fields you use to configure CP users in the local database.
Field
User Name
Password
User Group
Group ID
Page 178
Table 69: Local User Summary
Description
Shows the number of seconds the user can remain idle before the switch automatically logs
the user out. A value of 0 means that the user will not be logged out automatically.
Note: Idle timeout is not supported for wired clients.

Figure 87: Local User Configuration

Table 70: Local User Configuration

Description
Enter the name of the user. The range is 1-32 characters.
Enter an authentication password for the user. The password length can be from 8 to 64
characters.
Assign the user to at least one User Group. To assign a user to more than one group, press
the Ctrl key and click each group. The range is 1-32 characters. The default is Default.
New users are assigned to the 1-Default user group by default.
Unique group identifier. The range is an unsigned integer. The default is 1.
Software User Manual
02/15/2011
Document 34CS3000-SWUM104-D10