D-Link DWS-3000 Series User Manual page 65

Software User Manual
02/15/2011
Use the following procedures to add a VLAN to the discovery list by using the Web interface:
1 Use a browser to log on to the D-Link Unified Switch.
2 From the Navigation menu, click Administration > Basic Setup, then select the Discovery tab.
3 Make sure the box for L2/VLAN Discovery is selected and add the management VLAN ID of an AP or peer switch to
the VLAN (1-4094) field.
4 Click Add to add the VLAN to the list.
5 Click Submit to apply the changes.
From the Unified Switch, you can check the discovery status. To view information about whether the switch discovered the
AP, click the Monitoring > Access Points > Managed Access Points tab. If you have not added the MAC address of the
AP to the local or RADIUS Valid AP database, the AP appears in the Monitoring > Access Point > Authentication Failed
Access Points list, and the failure type is listed as No Database Entry. For more information about AP validation, see
"Authenticating and Validating Access Points" on page
The following example shows how to add a VLAN to the list by using the CLI.
1 From a Telnet, SSH, or serial connection, log on to the D-Link Unified Switch and enter the Wireless Configuration mode.
(switch-prompt) >enable
Password:
(switch-prompt) #config
(switch-prompt) (Config)#wireless
2 Add a VLAN to the discovery list:
(switch-prompt) (Config-wireless)#discovery vlan-list 4
3 Enter CTRL + Z to return to Privileged EXEC mode.
4 Save the changes to the configuration file:
(switch-prompt) #write
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n) y
Document 34CS3000-SWUM104-D10
D-Link Unified Access System
70.
Page 65