Front Panel Block Connector - FIC KT-748 Manual

Front Panel Block
Connector
This block connector includes
the connectors for linking with
Power LED (3-pin), HDD LED,
power button, power/sleep/
message waiting button, reset
buttonon the front panel of the
system case. Please identify
polarities of plug wires for the
case speaker and LEDs. Please
ask vendor about this informa-
tion when you buy them and
install the system by yourself.
The plug wires polarities of
these buttons will not affect
the function.
NOTE: Users that want to use IR port must adjust BIOS feature
UART Mode Select to set COM2 at some IR mode upon your IR
device.
(1) Reset Switch is connected to the reset button. Push this switch to reboot
the system instead of turning the power button off and on.
(2) HDD LED is connected to the IDE device indicator. This LED will blink
when the hard disk drives are activated.
(3) Power (Single and Dual) /Sleep LED
Please refer to the tables below for the representations of LED states.
There is another 3-Pin Power LED connector on board for some cases that with
a 3-pin plug.
Installation Procedures
2 - 11