Table of Contents
Advertisement
Onboard Serial Port 1/2
If the serial port 1/2 uses the onboard I/O controller, you can modify your
serial port parameters.The options are: 3F8/IRQ4, 3E8/IRQ4, 2F8/IRQ3, 2E8/
IRQ3, Disabled.
UART Mode Select
Allows you to select the IR modes if the serial port 2 is used as an IR port.
Set at Standard, if you use COM2 as the serial port as the serial port,
instead as an IR port. The options are: Normal, IrDA, ASKIR, SCR.
UR2 Duplex Mode
Allows you to select the IR modes. The options are: Half, Full.
Onboard Parallel Port
Allows you to select from a given set of parameters if the parallel port uses
the onboard I/O controller.
The options are: Disabled, 378/IRQ7, 278/IRQ5, 3BC/IRQ7.
Parallel Port Mode
Allows you to connect with an advanced printer via the port mode it sup-
ports. The options are: SPP, EPP, ECP, ECP+EPP.
ECP Mode Use DMA
This feature allows you to select Direct Memory Access (DMA) channel if
the ECP mode selected. The options are: 1, 3.
Onboard Lan Device
This feature allows users to enable or disable the onboard Lan device.
The options are: Enabled, Disabled.
Onboard Lan Boot ROM
This feature allows users to enable or disable the onboard Lan boot ROM
to boot system. The options are: Enabled, Disabled.
Init Display First
When you install a PCI VGA card on the board, this feature allows you to
select the first initiation of the monitor display from PCI or onboard AGP.
The options are: PCI Slot, AGP.
BIOS Setup
3 - 11
Advertisement
Table of Contents
