Front Panel Block, Power Led, Ir, And Speaker Connector - FIC P4M-865G MAX Manual

Front Panel Block, Power LED, IR, and Speaker Connector

This block connector includes the connectors for linking with Power LED (3-
pin), HDD LED, power button, power/sleep/message waiting button, reset
buttonon the front panel of the system case. Please identify polarities of plug
wires for the case speaker and LEDs. Please ask vendor about this information
when you buy them and install the system by yourself. The plug wires polari-
ties of these buttons will not affect the function.
NOTE: Users that want to use IR port must adjust BIOS feature IR
Controller Port to activate onboard IR featuere.
(1) Reset Switch is connected to the reset button. Push this switch to reboot
the system instead of turning the power button off and on.
(2) HDD LED is connected to the IDE device indicator. This LED will blink
when the hard disk drives are activated.
(3) Power (Single and Dual) /Sleep LED
Please refer to the tables below for the representations of LED states.
There is another 3-Pin Power LED connector on board for some cases that with
a 3-pin plug.
Installation Procedures
2 - 1 1