FIC KT-748 Manual page 42

KT-748 Mainboard Manual
HDD Off After
The option lets the BIOS turn the HDD motor off when system is in Sus-
pend mode. Selecting 1 Min..15 Min allows you define the HDD idle time
before the HDD enters the Power Saving Mode.
The options 1 Min..15 Min will not work concurrently. When HDD is in the
Power Saving Mode, any access to the HDD will wake the HDD up.
The options are: Disable, 1 Min..15 Min.
Power Button Override
The selection Delay 4 Sec. will allow the system shut down after 4 seconds
after the power button is pressed. The selection Instant-Off will allow the
system shut down immediately once the power button is pressed.
The settings are: Instant-Off, Delay 4 Sec.
Power State Resume Control
The item allows you to select the state that your personal computer re-
turns to after a power failure.
The settings are: Keep Pre-State, Always Off, Always On.
PM Wake Up Events
IRQ[3-7,9-15], NMI
Enable this feature will keep the system not in the Suspend mode when
IRQ3, 4, 5, 6, 7, 9, 10, 11, 12, 13, 14, 15, NMI.
The options are: Enabled, Disabled.
IRQ 8 Break Suspend
Enable this feature will make IRQ8 to resume the system from Suspend
mode. The options are: Enabled, Disabled.
RING Power Up Control
An incoming call via modem awakes the system from its soft-off mode.
The options are Disabled, Enabled.
PCIPME Power Up Control
When set at Enabled, a Power Management Event (PME) come from
PCIMAC will make the system from soft-off state.
The options are Disabled, Enabled.
3 - 14