Install The Cpu - FIC KT-748 Manual

KT-748 Mainboard Manual
2. Install DDR DIMM straight down
into the socket 1 using both hands,
then socket 2, and so forth.
3. The clip on both ends of the
socket will close up to hold the
DDR DIMM in place when the DDR
DIMM reaches the socket bottom.

3). Install the CPU

The mainboard has built-in Switching Voltage Regulator to support CPU Vcore
autodetection. That is, It has the ability to detect and recognize the CPU volt-
age, clock, ratio and enables users to set up the CPU frequency from the BIOS
Setup Screen. Users can adjust the frequency through Frequency / Voltage
Control of the BIOS Setup Screen.
CAUTION:
1. The heat sink and fan you installed must be approved by AMD.
2. The mainboard must be placed on a solid place to avoid shaking
|||||while install the heat sink and fan on the board.
3. The heat sink must be contact with the CPU top tightly.
4. Never run the processor without the heat sink properly and firmly
attached. PERMANENT DAMAGE WILL RESULT!
The procedures below shows you how to install your CPU and its fan
and heatsink. First of all, locate the CPU socket on this mainboard.
2 - 4