Windows 98 Users - Edirol UA-1EX Owner's Manual

Windows 98 users

The driver necessary for using the UA-1EX with Windows 98 is provided on the Windows CD-
ROM. Make sure that you have the Windows CD-ROM available.
* Some computers are sold with the contents of the Windows CD-ROM stored on the hard disk, and
therefore will not come with a Windows CD-ROM. If this is the case for your computer, you'll be able to
install the driver even without the Windows CD-ROM.
The USB composite device driver is installed first, then the USB audio device driver is
installed. Use the following procedure to install the drivers.
1. With the UA-1EX disconnected, start up Windows.
* Disconnect all USB cables except for a USB keyboard and USB mouse (if used).
2. Exit all currently running software (applications).
If you are using virus checking or similar software, be sure to exit it as well.
3. Place the UA-1EX's ADVANCED (mode select) switch in the OFF position.
4. Connect the UA-1EX to the computer.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after connecting the UA-1EX
is required before the unit will operate normally.
5. USB composite device will be detected automatically, and the "Add New Hardware Wizard"
dialog box will appear. Click [Next].
6. When "What do you want Windows to do?" appears, select
"Search for the best driver for your device (Recommended) ,"
and click [Next].
7. Check CD-ROM drive, and click [Next].
If the display indicates "Can't find an updated driver for this
device," check "Updated driver," and click [Next].
47