Windows Me/98 Users - Edirol UA-1EX Owner's Manual

Usb audio interface
Hide thumbs Also See for UA-1EX:
Table of Contents

Advertisement

Windows Me/98 users

1. With the UA-1EX left unconnected, start up Windows.
Do not connect the UA-1EX to the computer until you reach Step 9.
2. Exit all currently running software.
Also close any open windows. If you are using virus checking or similar software, be sure to exit it
as well.
3. Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive of your computer.
4. Click the Windows Start menu. From the menu that appears, select Run....
The "Run..." dialog box will appear.
5. In the dialog box that appears, input the following into the "Open" field, and click [OK].
D: \Driver\Me98\setup.exe
* The drive name is "D:" in the example shown here, but may be different on your system. Use the drive
name for your CD-ROM drive.
6. The Driver Setup dialog box will appear. Click [Next].
7. To begin the installation, click [Next] once again. Installation will begin.
The "Setup is now ready to install the drivers" dialog box will appear.
8.
Operation of the UA-1EX
* The driver cannot be installed by means of the following procedure if the switch is set to OFF.
9.
Operation of the UA-1EX
A message of "Found New Hardware" will appear. Please wait.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after connecting the UA-
1EX is required before the unit will operate normally.
10. In the Driver Setup dialog box, click [Close].
Next, you'll make the driver settings. (➔"Driver Settings" (p. 22))
Set the UA-1EX's ADVANCED (mode select) switch to the ON position.
Connect the UA-1EX to your computer.
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents