Edirol UA-1EX Owner's Manual page 12

Output indicator
7
This will light when an audio signal (sound) is being output from the line output jacks
headphone jack
ADVANCED (mode select) switch
8
This switches the driver mode. Normally, you should leave this ON.
ON
(Advanced mode)
OFF
(Standard driver
mode)
* If you change this setting, you must disconnect the UA-1EX from the computer and then reconnect it.
Input volume
9
This adjusts the volume of the audio signal (sound) that is being input to the mic input jack
and line input jacks
Digital input connector (optical)
10
Connect this when you want to input digital audio from an audio device such as a CD/MD/DAT.
Use an optical digital cable for connection.
Digital output connector (optical) / Headphone jack
11
The same jacks serves as both the headphone jack and digital output connector.
• You can connect an optical cable here, and output an audio signal in digital form to an MD
recorder or other digital audio device.
• You can connect headphones here. Even if headphones are connected, sound will still be
output from the Line output jacks
Optical
These are digital input/output jacks for connecting optical cables. Digital input/output jacks for
connecting coaxial cables are labeled Coaxial.
Headphones volume
12
This adjusts the volume that is output from the Headphone jack
* You can't adjust the volume that is output from the digital output connector and line output jacks.
12
.
11
This mode uses a dedicated audio driver created specifically for the UA-1EX.
Use this mode when you want to use your sequencer software or audio editing
software to record, play, or edit audio with high quality and stable timing.
This mode uses the standard audio driver provided by the operating system.
Use this mode when you want to use software that utilizes the functionality
specific to your operating system.
.
4
6
.
11
or the
6
3