Input/Output Device Settings - Edirol UA-1EX Owner's Manual

Input/output device settings

If you want to use the UA-1EX with the iTunes sequencer software included with your Macintosh,
specify the input/output devices as follows.
The procedure for making device settings differs depending on the sequencer software you are
using. For details, refer to the owner's manual for your software.
* What you actually see on your computer screen may be different, depending on your computing environment
and the operating system you're using.
1.
Operation of the UA-1EX
* The driver cannot be installed by means of the following procedure if the switch is set to OFF.
2.
Operation of the UA-1EX
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after connecting the UA-1EX is
required before the unit will operate normally.
3. Open "System Preferences" and click "Sound."
4. In the Sound Effects tab, set "Play alerts and sound effects through" to "EDIROL UA-1EX 44.1
kHz."
* Although "44.1 kHz" is used for the purpose of explanation within this document, this changes depending on
the actual setting of the Sampling frequency select switch on your UA-1EX.
5. In the Output tab, set "Choose a device for sound output" to "EDIROL UA-1EX 44.1 kHz."
* If you want sound to be output from the speakers of your Macintosh, disconnect the UA-1EX from your
Macintosh.
6. In the Input tab, set "Choose a device for sound input" to "EDIROL UA-1EX 44.1 kHz."
7. When you have finished making settings, close the dialog box.
Before you use your sequencer software with the UA-1EX, please note
the following
• Before you start up your sequencer software, connect the UA-1EX with your computer.
• Do not disconnect the UA-1EX while your sequencer software is running.
Close your sequencer software before you unplug the UA-1EX.
• The UA-1EX will not work in the Classic environment of Mac OS X. Use it when the Classic
environment is not running.
• For details on how to make settings for your sequencer software, you should also refer to the
owner's manual for your sequencer software.
This completes the audio input/output settings.
Proceed to "Checking that you hear sound" (p. 32).
Set the UA-1EX's ADVANCED (mode select) switch to ON.
Connect the UA-1EX to your Macintosh.
29