Memory Channel Programming - Icom ID-31A Instruction Manual

■ Memory channel programming

The Memory mode is very useful to quickly select often-used
operating settings.
[Example]: Programming 433.600 MHz/FM mode into
memory channel 11 (a blank channel).
q Push [V/MHz] to select the
VFO mode.
w Set a desired frequency and operat-
ing mode:
➥ Rotate [DIAL] to set a desired fre-
quency.
➥ Push [FM/DV] one or more
times to select a desired operat-
ing mode.
➥ Set other data (e.g. duplex di-
rection, frequency offset, tone
squelch, etc.), if desired.
e Hold down [S.MW]
ond to enter the Select Memory write
mode.
• 1 short and 1 long beep sound.
• The memory channel number blinks.
Blinks
for 1 sec-
Select Memory
write mode
r Rotate [DIAL] to select a desired
channel.
• Call channels (C0, C1), VFO and scan
edge channels (00A/00B to 24A/24B),
as well as regular memory channels,
can be programmed in this way.
t Hold down [S.MW] for 1 second
to program.
• 3 beeps sound.
• Before returning to the VFO mode, the
programmed memory contents are dis-
played for a moment.
• Memory channel number automati-
cally increases when continuing to hold
down [S.MW] for 1 second after
programming.
NOTE: Push [CLR]
the Select Memory write mode before memory program-
ming is finished.
BASIC OPERATION
Memory contents
is displayed for
a moment
After programming
is finished, return
to the VFO mode
to cancel the program and exit
5
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
28