Setting A Tuning Step; Setting A Frequency - Icom ID-31A Instruction Manual

5
BASIC OPERATION

■ Setting a tuning step

The following tuning steps are selectable.
• 5.0 kHz • 6.25 kHz
• 15.0 kHz • 20.0 kHz
• 50.0 kHz • 100.0 kHz
D Tuning step selection
q Push [V/MHz]
w Push to open the Quick Menu screen.
e Push D-pad(E) to select "TS," and
then push D-pad(Ent) .
D-pad
(Ent)
(�)
r Rotate [DIAL] to select the desired
tuning step.
t Push D-pad(Ent) to save the setting
and exit the Quick Menu screen.
23
• 10.0 kHz • 12.5 kHz
• 25.0 kHz • 30.0 kHz
• 125.0 kHz • 200.0 kHz
to select VFO mode, if necessary.
25 kHz tuning step

■ Setting a frequency

q Push [V/MHz] to select VFO mode, if necessary.
w Rotate [DIAL] to select the desired frequency.
• The frequency changes according to the selected tuning steps.
See the previous content to set the tuning step.
• When VFO mode is selected, push [V/MHz]
[DIAL] to change the frequency in 1 MHz steps. Or push [V/MHz]
again for 10 MHz* steps. (* Depending on versions, 10 MHz
tuning step is selectable.) Push [V/MHz]
[DIAL]
then rotate
again to cancel it.
The frequency changes accord-
ing to the selected tuning step.
After pushing [V/MHz] in the
VFO mode, [DIAL] changes the
frequency in 1 MHz or 10 MHz
steps.