Table of Contents
Advertisement
Service Mode
Projector Set-up
Highlight PROJECTOR SET-UP with the arrow keys and then press ENTER, to display the projector Setup menu.
Within the projector setup menu, the following items can be setup :
- Identification
- Total run time
- Change password
- Change language
- Change projector address
- Change baud rate
- Powerup mode
- Common address
- Barco logo
Identification
Highlight IDENTIFICATION using the arrow keys and then press ENTER.
The Identification screen displays information concerning :
-
Projector address. : To change the address of your projector,
-
Software version.
-
Configuration.
Possible configurations :
Front ceiling
Front table
Rear ceiling
Rear table
-
Baud rate PC. : Transfer speed for communication with an IBM PC or MAC. The Baud rate of the projector must be the
same as that of the connected computer. When there is a difference, contact a qualified service technician to make the
required changes.
-
Text on/off. : Indicates in operational mode if the bar scale and value will be displayed and if warnings will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the TEXT key once on the RCU.
-
Serial No. : Indicates the manufacturing serial number of the projector. This number can be useful when technical
assistance is required.
7 - 2 ___________________________________________________________________________________ R5975809 BARCO CINE 6
contact a qualified service technician.
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
or
Select with
then <ENTER>
<EXIT> to return
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUD RATE
POWERUP MODE : Standby
COMMON ADDRESS
BARCO LOGO
or
Select with
then <ENTER>
<EXIT> to return
Cine 6
PROJ. ADDRESS : 0
SOFT. VERSION : 1.01
CONFIG.
: front /
table
Baud Rate PC
: 9600
Text
: on
Serial No.
: 10359852
Advertisement
Table of Contents
