Eaton Powerware BladeUPS User Manual page 33

3. Remove the eight screws on the wireway top cover and retain.
Slide the cover back and off the wireway and retain. See Figure 5.
Figure 5. Removing the Wireway Top Cover (Bottom Entry Shown)
4. Remove the six screws on the conduit landing plate and retain.
Remove the plate and retain. See Figure 6.
Figure 6. Removing the Conduit Landing Plate (Bottom Entry Shown)
EATON Powerware
® BladeUPS ® (12 kVA) User's Guide
S
164201649 Rev 3 www.powerware.com
INSTALLATION
Ferrite Assembly
(mounted)
25