Unpacking The Cabinet - Eaton Powerware BladeUPS User Manual

INSTALLATION

Unpacking the Cabinet

S
S
To unpack the cabinet and accessories:
1.
2.
3.
Follow these guidelines when locating the cabinet after unpacking:
S
S
If installing a parallel system, continue to the following section, "Parallel
System Setup."
If installing a standalone UPS and optional EBM(s), continue to "EBM
Setup" on page 28. Otherwise, continue to "UPS Setup" on page 34.
20
EATON Powerware
Unpacking the cabinet in a low-temperature environment may cause condensation to
occur in and on the cabinet. Do not install the cabinet until the inside and outside of the
cabinet are absolutely dry (hazard of electric shock).
The cabinet and batteries are heavy (see page 114). A minimum of two people are
required to remove the cabinet and batteries from their cartons.
Cut the pallet straps and remove the large cardboard outer sleeve.
Have two people lift the sleeve for ease of removal.
Use care when moving and opening the cartons. Leave the
components packaged until ready to install.
Do not install the batteries until after the cabinet is installed in the
rack.
Discard or recycle the packaging in a responsible manner, or store it
for future use.
Place the cabinet in a protected area that has adequate airflow and is
free of humidity, flammable gas, and corrosion.
Avoid placing the cabinet on its side. Verify that the air vents on the
front and rear of the cabinet are not blocked.
® BladeUPS ® (12 kVA) User's Guide
C A U T I O N
S
164201649 Rev 3 www.powerware.com