Eaton Powerware BladeUPS User Manual page 118

UPS MAINTENANCE
3.
NOTE Treat the electronics module with care to avoid damaging the fans, connectors, or
internal circuitry.
Electronics Module
4.
110
EATON Powerware
Remove the UPS front cover and the electronics module and set
them aside (see Figure 56):
To remove the UPS front cover, grasp the fingergrips on both sides of
the cover and pull the cover forward firmly. Unplug the LCD cable
connecting the back of the control panel to the electronics module.
To remove the electronics module, remove the electronics module
locking screw at the top left of the electronics module and retain.
Grasp the ring handle at the middle of the module and pull the
module slowly out of the cabinet. Pull firmly to unseat the
connectors. Use two hands to support the module.
Locking Screw
LCD Cable
Figure 56. Removing the UPS Front Cover and Electronics Module
Label the original module with masking tape or some other
identifier. Record the serial number of the replacement module for
your warranty.
If not returning the electronics module for warranty, see the
following section, "Recycling the Used Battery or UPS," for proper
disposal.
® BladeUPS ® (12 kVA) User's Guide
Ring Handle
S
164201649 Rev 3 www.powerware.com