Tandberg Data StorageLoader Installation And User Manual page 61

Tandberg Data
4. The appropriate FW file must be located on the same directory as the FlashIt
utility.
5. Start the FlashIt utility and follow the instructions in the program.
6. As the Download Utility begins data transfer, the
StorageLoader displays this message:
7 When the FW image file has been downloaded, the
loader checks the integrity of the FW image while
displaying this message:
8 Once the code is approved the loader starts the erase
and reprogram operation while displaying this
message:
During the Erase part of the reprogramming cycle,
the Amber LED is lit to warn against interference.
The erase operation takes less than 20 seconds.
During the Programming part of the reprogramming
cycle, the Green LED flashes in addition to the
Amber LED being lit. The programming operation
takes less than one minute.
9 When reprogramming is completed, the loader will
do a normal reboot
If the firmware upgrade operation failes during point 8 due to a power shut-down or
similar, the loader may require service.
To verify that the FW version in the loader is correct, enter the view data menu.
Select the "Autoloader Info" and from there the "Loader Firmware Revision" entry
to see the revision number.
StorageLoader Installation and User Manual
Maintenance
Flash Firmware
SCSI Update:
Transferring Data
Flash Firmware
SCSI Update:
Checking ECC
Flash Firmware
SCSI Update
Reprogramming
Do not interfere!
53