Remote Management Web; Information Boxes; Figure 5.1 Navigation Menu - Tandberg Data StorageLoader Installation And User Manual

Tandberg Data
panel set Setup → Remote management setup → IP address mode to DHCP
mode.
3. Via the front panel, first set Setup → Remote management setup → Access
control → Allow remote management to Not allowed and select OK. Then set
the same value to Allowed and select OK. This will restart the networking
subsystem. Getting a new IP address may take some time if the StorageLoader is
in DHCP mode.
4. Check the IP address via the front panel by accessing either View Data →
Remote management info → Sta IP addr. state or View Data → Remote
management info → Dyn IP addr. state depending on whether the StorageLoader
is in static or dynamic IP address mode.
5.2 Remote management web pages
Most of the operations you can perform from the front panel can also be performed
remotely using Web Administration. The Remote Management interface provides
access to loader and drive status and statistical operation information.
The Web pages include a
navigation menu making it
easy to use, see figure 5.1.

5.2.1 Information Boxes

All the Remote Management web pages show StorageLoader and drive information.
This information includes:
• StorageLoader information containing model, serial number, firmware
version, cumulative power-on time and present activity of the loader.
• Drive information containing technology, serial number, firmware version
and activity.
44
Status
Settings
Personalization
Network
SCSI-ID
Cleaning options
Command
Maintenance
Diagnostics
Debugging

Figure 5.1 Navigation Menu

StorageLoader Installation and User Manual
Remote Management