Settings; Command Page - Tandberg Data StorageLoader Installation And User Manual

Tandberg Data
• Yellow
• Red
If you click on a slot, additional cartridge information will be shown in a pop up
window. This information includes the cartridge barcode (if label and barcode
reader is installed) and the error code.
5.2.4 Settings Pages
On the setting pages, you can change the StorageLoader configuration. These pages
can only be accessed by someone who is logged in as Administrator.
Personalization
On this page you can change the Remote Management passwords. To secure your
system, change both the passwords the first time you use the system. It is possible to
clear the remote management passwords via the front panel, please see section 4.6.1
The Maintenance Menus.
Here you may also turn on email event notification. When event notification is
enabled, the StorageLoader will send warnings and errors by email to the recipient's
e-mail address.
Network
On this page it is possible to change the IP configuration. See details in chapter
Remote Management setup. The new configuration will take effect at next system
reset.
Warning: Please verify that the chosen settings are correct and consistent before
resetting the loader. Any mistakes will have to be corrected via the front panel.
SCSI-ID
On this page it is possible to change the SCSI-ID on your drive and loader. See
details in section 4.4.2, SCSI Setup.
Cleaning Options
By defining a cleaning slot, the StorageLoader will regard the cartidge in this slot as
the cleaning cartridge unless:
1. another cartridge has previously been reported to be a cleaning
cartridge by the drive, or
2. the loader contains a cartridge with a bar code label indicating that it
is a cleaning cartridge.

5.2.5 Command Page

On this page it is possible to move cartridges between magazine slots and drive. All
cartridges in the StorageLoader will be found in a pull-down list sorted by location.
StorageLoader Installation and User Manual
Warning
Error
Remote Management
47