Axis 5400 User Manual page 69

AXIS 5400+ User's Manual
About AXIS Print
Utility for OS/2
Installing the
AXIS 5400+
AXIS Print Utility for OS/2 is an application for NetBIOS/NetBEUI
printing in the OS/2 environment. Its allows you to:
• Install and maintain the AXIS 5400+ printer ports as OS/2
printer ports.
• Capture and monitor print jobs directed to the AXIS 5400+
ports.
Print jobs are directed through a spool directory located on your local
hard disk (peer-to-peer mode), or on the file server (client-server
mode). The printer port status of your AXIS 5400+ can be monitored
and pop-up notification messages can be generated, keeping you
informed of completed print jobs or any problem condition.
Notes:
The NetBEUI protocol must be active. If not, use MPTS/LAPS (LAN Server) or
SETUP (LAN Manager) to activate it.
If you are using OS/2 version 2.x and wish to print through TCP/IP, we
recommend that you use the IBM TCP/IP for OS/2 product. It supports the LPD
and interactive FTP print methods.
1. When AXIS Print Utility for OS/2 is running, click Install to
install your AXIS 5400+. The port appears in the list as
<name>.LP1, where <name> is AX followed by the last six digits
of your print server serial number. e.g. AX100086.LP1.
2. Select the port that you want to install, then click Install.
Repeat this procedure for each server using the AXIS 5400+.
The AXIS Print Utility for OS/2 must be running in order to print
through your AXIS 5400+. It is strongly recommended that you
modify the startup.cmd file, enabling AXIS Print Utility for OS/2 to
automatically start when your client is re-booted. Instructions are
available in the AXIS Print Utility for OS/2 Readme file.
Section 6: Setting Up - OS/2
69