Axis 5400 User Manual page 140

Section 11: Upgrading the Software
140
Upgrading using
AXIS NetPilot
4. Type the command:
put <software name> FLASH
where
<software name>
software, e.g.
5400+_620.bin
5. Wait for the Flash loading operation to finish. This normally
takes 1 to 4 minutes. The unit automatically restarts with the new
print server software.
6. Log out using the command:
or
quit, bye exit
depending on your FTP version.
Note:
Should you encounter any problem that prevents a successful upgrade over your
network, it may become necessary to perform the flash loading operation via the
parallel port, LPT1. In this case, you are advised to contact your dealer.
This method is recommended for upgrading the flash memory in
NetWare networks. An Upgrade Wizard is available to guide you
through the necessary procedures.
Follow the instructions below to upgrade your print servers:
1. Obtain the firmware file, using one of the methods presented on
page 137.
2. Put the file in the AXIS NetPilot 'Upgrade' folder. This folder
resides in the same folder as the AXIS NetPilot program and was
created when AXIS NetPilot was installed on your client.
3. Start the Upgrade Wizard by clicking on the Upgrade icon on the
AXIS NetPilot toolbar.
4. Proceed the installation by following the instructions that are
presented to you in the Upgrade Wizard.
If you need more information, please refer to AXIS NetPilot on-line
help.
AXIS 5400+ User's Manual
is the name of the new print server