Axis 5400 User Manual page 45

AXIS 5400+ User's Manual
Using the Microsoft
LPD monitor with
Window NT 3.5x
Basic Setup
Install the TCP/IP
Protocol Stack
8. Select the AXIS Port you wish to add and then click OK. The
port appears as <name>.LP1, where <name> is AX followed by
the last six digits of the AXIS 5400+ serial number, e.g. xxx
(default serial no.).
9. Click on Settings. Choose whether error condition pop-up
messages are to be displayed by checking the box in the Configure
Axis Ports dialog. Click OK.
This section describes how to set up a Windows NT Server
v3.5 and v3.51 for LPD printing over the TCP/IP protocol, using the
built-in Microsoft LPD monitor.
If you have not already done so, you should perform the TCP/IP basic
setup procedures prior to installing a printer for LPD printing. These
procedures are defined in Assigning an IP address, on page 22 and
onwards.
In the Control Panel, click the Network icon. If the TCP/IP Printing
entry appears, then TCP/IP is already installed. Close the Network
folder and continue with Installing a printer on the next page.
Follow these steps to install the TCP/IP protocol stack:
1. In the Control Panel, select Network.
2. Click Add Software...
3. Select "TCP/IP Protocol and related components" and then
click Continue.
4. Check "TCP/IP Network Printing Support" and then click
Continue.
5. Select path and then click Continue.
6. Click OK in the Network Settings dialog box.
Section 4: Setting Up - Windows
45