Axis 5400 User Manual page 139

AXIS 5400+ User's Manual
Upgrading over the
Network using FTP
Caution
2. Select a network group from the drop-down list. You can only
update the servers that are included in the selected network group.
3. All AXIS servers included in the network group appear. Click the
Firmware button to start the Upgrade Wizard.
4. Follow the instructions that are presented to you to complete the
installation.
Refer to Using AXIS ThinWizard, on page 98, for more information
about AXIS ThinWizard.
To upgrade over the network using FTP you will need the file with the
new print server software. The name of this file is in the form
product_version.bin
6.20. You can use any of the previously mentioned methods to obtain
the new file.
You must assign the AXIS 5400+ with an IP address, as described in
Assigning an IP address, on page 22, before you can use this upgrading
method.
Follow the procedures below to upgrade the AXIS 5400+:
Be careful not to interrupt the file transfer. If the transfer is interrupted the AXIS
5400+ may have to be re-initialized by your dealer.
1. Log in to the AXIS 5400+ with the command:
ftp <host name>
2. You will be prompted for user id and password. Use the user id
, which has the default password
root
3. Type the command:
binary
to change to binary transfer mode.
Section 11: Upgrading the Software
, e.g.
5400+_620.bin
, or
ftp <IP address>
pass
for software release
.
139