Restore Configuration; Reset To Factory Defaults - ZyXEL Communications PMG2006-T20A User Manual

Restore Configuration

Restore Configuration allows you to upload a new or previously saved configuration file from your
computer to your PMG2006-T20A.
Table 82 Restore Configuration
LABEL DESCRIPTION
File Path Type in the location of the file you want to upload in this field or click Choose File to find it.
Choose File Click this to find the file you want to upload. Remember that you must decompress compressed
(.ZIP) files before you can upload them.
Upload Click this to begin the upload process.
Do not turn off the PMG2006-T20A while configuration file upload is in
progress.
After the PMG2006-T20A configuration has been restored successfully, the login screen appears. Login
again to restart the PMG2006-T20A.
The PMG2006-T20A automatically restarts in this time causing a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
Figure 106 Network Temporarily Disconnected
If you uploaded the default configuration file you may need to change the IP address of your computer
to be in the same subnet as that of the default device IP address (192.168.1.1).
If the upload was not successful, the following screen will appear. Click OK to go back to the
Configuration screen.
Figure 107 Configuration Upload Error

Reset to Factory Defaults

Click the Reset button to clear all user-entered configuration information and return the PMG2006-T20A
to its factory defaults. The following warning screen appears.
Chapter 29 Backup/Restore
PMG2006-T20A User's Guide
148