Pptp Vpn Tutorial; Configuring Pptp Vpn Setup (Server) - ZyXEL Communications SBG3500-N000 User Manual

Note: The policy for the remote VPN client is not shown in the screen because it is an
unknown to the remote access VPN client.

4.14 PPTP VPN Tutorial

The example uses the following settings in setting up a basic PPTP VPN tunnel.
Figure 15 PPTP VPN Example
LAN Subnet #1: 192.168.1.0/24
LAN Subnet #2: 192.168.2.0/24
• The Device has a static IP address of 172.16.1.2 for the DSL WAN interface.
• The remote user has a dynamic IP address and connects through the Internet.
• Use the default IP address pool to assign the remote users a point-to-point IP addresses from
10.1.1.1 to 10.1.1.32 for use in the PPTP VPN tunnel.
• The access group configuration allows the remote user to access only the LAN subnet #1
192.168.1.0/24.

4.14.1 Configuring PPTP VPN Setup (Server)

1.Go to the VPN > PPTP VPN > Setup screen and configure the following.
• Select the Enable checkbox.
• Set Access Group 1 to 192.168.1.0/255.255.255.0.
• Select DNS as User Defined and enter a DNS server address. The DNS server address in this
example is 8.8.8.8.
SBG3500-N000 User's Guide
172.16.1.2
Chapter 4 Tutorials
PPTP VPN IP Address Pool:
10.1.1.1 - 10.1.1.32
69