Installation Instructions - AEG Electrolux KB9820E User Manual

Problem
The oven lighting is not
operating
"d" is lit in the display
and the oven is not heat-
ing up. Fan not operating
If you are unable to remedy the problem by following the above suggestions, please
contact your dealer or the Customer Care Department.
WARNING!
Repairs to the appliance must only be carried out by qualified service engineers. Consid-
erable danger to the user may result from improper repairs.
In the event of incorrect operation, visits by engineers from Customer Service or the dealer
may be chargeable, even during the warranty period.
Information for appliances with metal fronts: Due to the cool front of your appliance, there
may be short-term condensation of the inner door glass after opening the door, during or
shortly after baking or roasting.

Installation instructions

CAUTION!
The new appliance may only be installed and connected by a registered installation engineer.
Please comply with this instruction. If you do not, any damage resulting is not covered by
the warranty.
To prevent future hazards, damaged mains cables must only be replaced by a qualified
electrician.
Possible cause
The clock has not been set
The required settings have not
been made
The oven's automatic switch-off
has been triggered
The child safety device is activated. Switching off the child safety de-
The house wiring fuse (in the fuse
box) has tripped
The oven light bulb is faulty
Test mode is switched on
Remedy
Set the current time on the clock
Check the settings
See Automatic switch-off
vice
Check fuse. If the fuses trip several
times, please call a qualified elec-
trician
Replace oven light bulb
Switch off the appliance. Press and
hold the and buttons at the
same time, until signal sounds and
"d" display goes out.
49