Limiting Wan Bandwidth And Enabling Wan Connection Detection - NetComm HS1200N User Manual

Limiting WAN bandwidth and enabling WAN connection detection

To limit the WAN bandwidth and enable WAN connection detection, click the Main Menu button, then System and then WAN
Traffic.
Limiting WAN bandwidth
This feature gives administrators control over the entire system's traffic on the WAN interface. These parameters set here should not
exceed the real bandwidth provided by your ISP. For example, if your xDSL is 8Mbps/640kbps, you may input values equal to or
less than the speed here.
Available Bandwidth on WAN Interface:
Uplink: Specifies the maximum uplink bandwidth that can be shared by clients of the system.
Downlink: Specifies the maximum downlink bandwidth that can be shared by clients of the system.
Enabling WAN connection detection
When this function is enabled, the gateway will try to access these IP/Domain addresses. If the gateway can reach these IP/Domain
addresses, the Internet connection is deemed to be functioning normally.
WAN Connection Detection:
IP/Domain Name: Enter the IP address or domain name that the gateway will use to verify the internet connection
status.
The Warning of Internet Disconnection option allows you to specify a message that is displayed on a user's screen when they
access a web page and the internet connection is down.
www.netcommwireless.com NetComm Wireless HS1200N Wireless N Hotspot
27