Qos Profile - NetComm HS1200N User Manual

Rule Number: This is the rule selected "1". Rule No. 1 has the highest priority; rule No. 2 has the second highest priority, and so on.
Rule Name: The rule name can be changed here.
Source/Destination – Interface/Zone: There are choices of ALL, WAN, Public and Private to be applied for the traffic interface.
Source/Destination – IP Address/Domain Name: Enter the source and destination IP addresses. Domain Name filtering is supported
but Domain Host filtering is not.
Source/Destination – Subnet Mask: Select the source and destination subnet masks.
Source- MAC Address: The MAC Address of the source IP address. This is for specific MAC address filtering.
Service Protocol: These are defined protocols on the service protocols list to be selected.
Schedule: When schedule is selected, clients assigned with this policy are applied the firewall rule only within the time checked.
There are three options, Always, Recurring and One Time. Recurring is set with the hours within a week.
Action for Matched Packets: There are two options, Block and Pass. Block is to prevent packets from passing and Pass is to
permit packets passing.

QoS Profile

Up to 5 QoS profiles can be configured for certain applications or users that need stable bandwidth or traffic priority. Bandwidth
Control can only be Enabled when Bandwidth limits on WAN has been Enabled.
Traffic Class: Traffic Class can be chosen for users on IPv4 or IPv6. Default DSCP (Differentiated Services Code Point) can be
added and edited to determine traffic class. Default DSCP includes: Network Control 0x30, Telephony 0x2E, Signaling 0x28, Multi-
media Conferencing 0x26, Real-Time Interactive 0x20, Multi-media Streaming 0x1A, Broadcast Video 0x18, Low-latency Data
0x12, OAM 0x10, High-Throughput Data 0x0A, Standard 0x00, Low Priority Data 0x08.
Bandwidth Control: Enable or Disable the capability to determine the following parameters.
Group Total Downlink: Defines the maximum bandwidth allowed to be shared by clients.
Individual Maximum Downlink: Defines the maximum downlink bandwidth allowed for an individual client. The Individual Maximum
Downlink cannot exceed the value of Group Total Downlink.
Individual Request Downlink: Defines the guaranteed minimum downlink bandwidth allowed for an individual client. The Individual
Request Downlink cannot exceed the value of Group Total Downlink and Individual Maximum Downlink.
Group Total Uplink: Defines the maximum uplink bandwidth allowed to be shared by clients.
Individual Maximum Uplink: Defines the maximum uplink bandwidth allowed for an individual client. The Individual Maximum Uplink
cannot exceed the value of Group Total Uplink.
Individual Request Uplink: Defines the guaranteed minimum bandwidth allowed for an individual client. The Individual Request Uplink
cannot exceed the value of Group Total Uplink and Individual Maximum Uplink.
NetComm Wireless HS1200N Wireless N Hotspot
62
www.netcommwireless.com