Table of Contents
Advertisement
Hardware Installation
Wireless Hotspot
Please follow the steps below to install the HS1200N Wireless N Hotspot.
1.
Place the HS1200N in the location that provides the best possible signal.
The best location for the HS1200N is usually at the centre of your wireless network. This ensures it is able to get a clear wireless
signal.
2.
Connect the HS1200N to your outbound network device.
Connect one end of the supplied Ethernet cable to the WAN port on the front of the HS1200N. Connect the other end of the
Ethernet cable to the device in use that will be used to provide access to the Internet. This may be an ADSL Router, a cable modem
or a switch/hub. The WAN LED illuminates to indicate a proper connection.
3.
Connect the HS1200N to your local area network device.
Connect one end of an Ethernet cable to the LAN1 port on the front of the HS1200N. Connect the other end of the cable to the
Ethernet port on the computer being used to configure the HS1200N. The LAN1 LED illuminates to indicate a proper connection
has been made.
Note: The HS1200N has two virtual 'zones' (Private and Public). These zones are mapped to LAN1 (192.168.110.1) and LAN2
(192.168.120.1) respectively.
4.
Connect the power supply to the HS1200N.
Connect the DC power adapter to the power socket on the rear panel of the HS1200N. Wait up to 10 minutes for the router to start
up.
Note:
Only use the power adapter supplied with the HS1200N. Using a different power adapter may damage the system.
To verify the wired connection between the HS1200N and the switch/hub/router, you can also check the LED status
indicators of these network devices.
Wireless Ticket Generator and Thermal Printer
Please follow the steps below to install the Wireless Ticket Generator and Thermal Printer.
1.
Place the Wireless Ticket Generator and Thermal Printer close to one another and in the position you would like to use them.
2.
Attach the included WiFi antenna to the WiFi antenna connector on the Wireless Ticket Generator by turning it clockwise.
3.
Connect the smaller end of the included console cable to the console port of the Wireless Ticket Generator and connect the
larger end to the console port on the rear panel of the Thermal Printer. Tighten the shoulder screws on both ends of the
console cable to prevent accidental disconnection.
4.
Connect the supplied 5V / 3.0A power supply to the power jack on the right side panel of the Wireless Ticket Generator.
5.
Connect the supplied 8.4V / 3.0A power supply to the power jack on the rear panel of the Thermal Printer. Use the power
switch on the rear panel of the Thermal Printer to turn it on.
Establishing a wireless connection
The Wireless Ticket Generator must establish a secure connection with the Wireless N Hotspot in order to create user accounts and
send this information to the Thermal Printer. To establish a secure connection, on the Wireless Ticket Generator, press and hold the
TAS button on the left panel for 3 seconds and then release it. The Wireless Ticket Generator searches for the Wireless N Hotspot
and creates a secure connection between them. This process takes about 30 seconds.
The hardware setup is now complete.
NetComm Wireless HS1200N Wireless N Hotspot
14
www.netcommwireless.com
Advertisement
Table of Contents
