1
1. Connect the power to your NetComm m1 by either:
A) Plugging the supplied power adapter into a wall power outlet and then into
to the port labelled "Power" on the side of the NetComm m1.
B) Plugging the supplied USB cable into the port labelled "Power" on the
NetComm m1 and the other end into a compatible USB port on your laptop/
desktop computer.
2. Slide the power switch to the "ON" position and wait for approximately
2 minutes to allow the device to start up.
3. Connect a compatible 3G USB Modem to the "3G USB" port on the NetComm m1.
Hardware Installation
3G Tower
Power Point
Power Adapter
Laptop
USB
Modem
OR