Status Data Byte 5, Bit 2 - Edit Preset Ltc; Status Data Byte 5, Bit 4 - Edit Preset Video; Status Data Byte 5, Bit 5 - Edit Preset Assemble; Status Data Byte 5, Bit 6 - Edit Preset Insert - AJA Ki Pro Ultra Control Manual

3.34. Status Data Byte 5, Bit 2 – Edit Preset LTC
This bit reflects the LTC edit preset value set by the Edit Preset command. This
device has limited edit support. Please refer to the "Editing" section below for
further details.
3.35. Status Data Byte 5, Bit 4 – Edit Preset Video
This bit reflects the Video edit preset value set by the Edit Preset command. This
device has limited edit support. Please refer to the "Editing" section below for
further details.
3.36. Status Data Byte 5, Bit 5 – Edit Preset Assemble
This bit reflects the Assemble edit preset value set by the Edit Preset command.
This device has limited edit support. Please refer to the "Editing" section below
for further details.
3.37. Status Data Byte 5, Bit 6 – Edit Preset Insert
This bit reflects the Insert edit preset value set by the Edit Preset command. This
device has limited edit support. Please refer to the "Editing" section below for
further details.
3.38. Status Data Byte 6, Bit 4 – Reverse Lamp
This bit will be high whenever the device's transport is moving in reverse.
3.39. Status Data Byte 6, Bit 5 – Forward Lamp
This bit will be high whenever the device's transport is moving forward.
3.40. Status Data Byte 6, Bit 6 – Still Lamp
This bit will be high whenever the device's transport is still.
3.41. Status Data Byte 10, Bit 0 – Deterministic Play Armed
This bit will be high whenever the device has been armed for deterministic
playback via the deterministic play arm command. However, it will only be set if
the conditions support arming for deterministic playback (see the "Deterministic
Playback" section for further details). It will be cleared upon completion of a
deterministic playback.
Ki Pro Ultra and Ki Pro Ultra Plus Machine Control Guide 20 www.aja.com