Media Menus; Media Menu Parameters; Media State - AJA Ki PRO rack Operation Manual

MEDIA menus

Media Menu
Parameters

12.1 Media State

Ki Pro Rack v4.2
"WARNING No Video Input" appears when an attempt was made to record but no video
was detected on the input. Check connections and sources to make sure valid video is
being fed to the input selected in 2.1 Video Input.
"WARNING 2 Channel Format" appears when the number of channels selected in 2.3
Audio Channels is eight, but the selected audio input only supports two channels. Only
SDI supports eight channels.
"WARNING Genlock Missing" appears when 6.1 Genlock has been set to INPUT or
Component Y but there is no signal detected on the chosen genlock input.
"WARNING Genlock Mismatch" appears when 6.1 Genlock has been set to INPUT or
Component Y but the signal detected on the selected genlock input is incompatible with
the video format on the selected video input.
"WARNING Non VFR Format" appears when 1.1 Record type is set to VFR (variable frame
rate), but the video to record is not a valid VFR type. This can happen because the video
format on the selected video input doesn't support or isn't carrying VFR ancillary data, or
the video signal generator is enabled in 41.2 VIDEO SG or 1.4 Input Conversion is
enabled.
"WARNING No Clip Name" appears when an attempt was made on a ganged slave unit to
set the clip name to use from a master, but the name was empty. The custom clip name
on the master may be empty.
"WARNING Unsupported Media" appears when a USB-only or SxS card was inserted into
the Ki Pro Rack's ExpressCard/34 slot. These types of media are not supported by Ki Pro
Rack. Choose an ExpressCard/34 from the approved list on AJA's website.
"WARNING Please Reboot" appears when media was removed without using the slot
button and the Ki Pro cannot continue operating without rebooting.
As the name implies, the MEDIA menus display choices related to media storage, the
type of encoding, and how Ki Pro Rack behaves when recording and playing back. There
are also menus for naming reels, clips and takes.
This parameter applies to using the Ki Pro Rack to transfer data. These are the available
options:
Record-Play (default)
Data-LAN*
See "Data-LAN Considerations" on page
]For normal video operation, select Record-Play. For data transfer using an Ethernet LAN,
choose Data-LAN.
If the state is designated as Data, the Transport functions are locked; in other words,
media cannot be recorded or played back as video. You can still access MEDIA menu
parameters, however, so you can reset the parameter. If you attempt to playback or
Use media to record and play video.
LAN data may be uploaded/downloaded from the Ki Pro.
37.
36 www.aja.com