AJA Ki PRO rack Operation Manual page 35

"WARNING Dropped Frames" may appear if media is underperforming and cannot keep
up with the data rate required to make a recording or perform a playback. If you see this
prompt during recording, you might consider backing up your current recordings and
formatting the media. For playback, you might simply re-attempt playback.
"WARNING SDI VFR Mismatch" will appear if you have set the video input to something
other than SDI when parameter 1.1 is set to "VFR"—as only the SDI input provides the
appropriate data for VFR support.
"WARNING Media Low" will appear when the media only has 15% of capacity remaining.
Media must be switched out when it reaches 10% of capacity. With 10% of media
remaining, the "WARNING Media Full" prompt will appear.
"WARNING Media in Use" may appear if you try to remove the media by pushing the SLOT
button while an operation is still taking place. Wait for the operation to finish and then
try again.
"WARNING Media Not Present" may appear if media has been physically removed and
the user pushes the slot button.
"WARNING Media Invalid" may appear if the media could not be formatted or contained
errors the Ki Pro Rack was not able to correct. To resolve this issue, mount the drive on
an Apple computer under Mac OSX, copy the clips from the media, then re-insert the
media into Ki Pro Rack. If it does not read properly, you will need to format the media.
"WARNING Storage Removed" will appear if the media is removed without first hitting
the SLOT button to properly unmount media. In the event this happens, media
immediately re-inserted into the Ki Pro Rack may show clips as "N/A" and subsequent
recordings may not be possible. To resolve this issue, mount the drive on an Apple
computer under Mac OSX, then re-insert the media. If it does not read properly, you will
need to format the media.
"WARNING Backup and Reformat" may appear if media has issues being mounted by the
Ki Pro Rack. As the prompt indicates, it is best to back up the media by copying it to
another drive or disk array and then reformat the media. Some signs that the media is in
a read-only state: even though clips have been recorded to the media, "N/A" appears in
the clip area of the UI, "Loading" appears in the clip area of the UI but does not
eventually load a clip, or hitting the record button with all settings correctly configured
for the Ki Pro Rack does not result in a recording.
"WARNING Media Unformatted" appears when media was inserted that contains no
filesystem recognized by Ki Pro Rack. Ki Pro Rack recognizes HFS+ filesystems; media
with other types of filesystems may appear unformatted to Ki Pro Rack. Unformatted
media or media with other types of filesystems (FAT32, etc.) may be formatted by the
usual means.
"WARNING Change Encode Type" appears because ProResHQ is not supported on
ExpressCard/34. Select another flavor of ProRes (normal, LT or Proxy) before attempting
to record to an ExpressCard/34.
"WARNING Invalid Selection" appears when Ki Pro Rack receives conflicting configuration
requests, such as selecting component in/out "Beta" for HD.
"WARNING Name In Use" appears when an attempt was made to record over a previously
existing clip. This can happen when the take number reaches its maximum, 999. To
resolve it change one of the clip naming parameters to eliminate the naming conflict.
Ki Pro Rack v4.2 35 www.aja.com