SMC Networks SMCD3GN2 User Manual page 76

Adding Predefined Access Rules
Using the following procedure, you can select a well-known service and specify whether to
block all LAN hosts, a single LAN host, or a range of LAN hosts.
1. In the Access Control menu, check Enable Access Control if it is not checked and click
the Apply button. The remaining fields in the menu become available.
2. Under Predefined Service Table, click the Add button. The Predefined Access Rules
menu appears (see Figure 43).
3. Complete the fields in the Predefined Access Rules menu (see Table 18).
4. Click Apply. (Or click Back to return to the Access Control menu or Cancel to cancel any
selections you made.) If you clicked Apply, the rule for the predefined access rule is added
to the Predefined Service Table.
5. To configure additional access control rules for predefined services (up to 35, including
access rules for customer-defined services), repeat steps 2 through 4. When you finish,
click Apply in the Access Control menu to save your settings.
6. To change the rule for a predefined rule, click the radio button to the left of the rule you
want to change and click the Edit button. When the Predefined Access Rules menu
appears, edit the settings as necessary (see Table 18) and click Apply. Click Apply in the
Access Control menu to save your settings.
7. To delete a predefined rule, click the radio button to the left of the rule you want to delete
and click the Delete button. No precautionary message appears before you delete a rule.
Click Apply in the Access Control menu to save your settings.
Configuring Your Gateway
76
SMCD3GN2 Wireless Cable Modem User Manual