Channel Programming - Icom IC-V80 Instruction Manual

6
MEMORY/CALL OPERATION

■ Channel programming

q Push [VFO/MR/CALL] several times to select the VFO
mode.
w Set a desired frequency. (p. 16)
➥ If desired, set other data (e.g. offset frequency, duplex
direction, tone squelch, etc.).
e Push [FUNC](M), and then [VFO/MR/CALL].
• "X" and the memory channel number blink.
• Select the Call channel mode to program the Call channel.
r Push [] or [] to select a desired channel.
• Select "1A/1B" to "3A/3B" to program a scan edge channel.
25
• Example— programming 145.440 MHz into memory channel 11 (a blank channel).
Push , and then
The VFO mode
Push
t Push [FUNC](M), and then push and hold [VFO/MR/
CALL] for 1 sec. to store the entry.
• 3 beeps sound.
• If you continue to push and hold [VFO/MR/CALL] for 1 sec.
after programming, the memory channel number automatically
increases.
NOTE: To cancel programming, push [VFO/MR/CALL]
before storing the entry in step t.
.
Push or
, then push and hold for 1 sec. to program.
Return to the VFO mode.
to select channel 11.