Table of Contents
Advertisement
PROGRAMMING TX AND RX FREQUENCIES ON A CHANNEL
The easiest case is programming the same frequency in transmission and in reception. This
way of programming a handset is called « SIMPLEX » mode.
If your transmission frequency TX is different from your reception frequency RX, you will
have to follow the instructions carefully to introduce them in the correct place in the
programming sequence.
For example, we will program a frequency of 152.540 MHz on channel 8, in simplex
mode, meaning the TX and RX frequencies are the same.
SEQUENCE
1
TRANSCEIVER OFF
2
PRESS SIMULTANEOUSLY ON
PTT
TRANSCEIVER ON
3
KEY IN ACCESS CODE (
CONFIRM BY PRESSING
4
PRESS SIMULTANEOUSLY ON
PROGRAMMING PER CHANNEL
AT THIS POINT YOU CAN PROGRAM THE CHANNEL IN A « BANK ». THERE ARE 6
« BANKS » OF 16 CHANNELS EACH.
THE SELECTION OF A « BANK » IS DONE BY PRESSING
IF YOU WANT TO SAVE YOUR FREQUENCY ON CHANNEL 5 OF « BANK » 2, YOU
WILL HAVE TO SELECT « BANK » 2 USING
DISPLAYED IN THE TOP LEFT CORNER.
Guideline Télécom MSFB
ACTION
Po
AND
AND TURN
159357
2
AND
ONTHE KEYPAD TO ACCESS THE
Technical Sheets
OR
) AND
258456
P 1
P 1
AND CHECK THAT FIGURE 2 IS
ICOM IC-F30 LT
DISPLAY
- - - - - - -
SET MODE
CH 01
12
05/08/2002
Advertisement
Table of Contents
Need help?
Do you have a question about the IFC-30LT and is the answer not in the manual?
Questions and answers