Chapter 14
Configuring Object Tracking
S e n d d o c u m e n t c o m m e n t s t o n e x u s 3 k - d o c f e e d b a c k @ c i s c o . c o m
switch(config-track)# vrf member Blue
switch(config-track)# copy running-config startup-config
Verifying the Object Tracking Configuration
To display the object tracking configuration information, perform one of the following tasks:
Command
show track [object-id] [brief]
show track [object-id] interface [brief]
show track [object-id] ip route [brief]
Configuration Examples for Object Tracking
This example shows how to configure object tracking for route reachability and use VRF Red to look up
reachability information for this route:
switch# configure terminal
switch(config)# track 2 ip route 209.165.201.0/8 reachability
switch(config-track)# vrf member Red
switch(config-track)# copy running-config startup-config
Related Topics
See the following topics for information related to object tracking:
•
•
Additional References
For additional information related to implementing object tracking, see the following sections:
•
•
Chapter 9, "Configuring Layer 3 Virtualization"
Chapter 12, "Configuring HSRP"
Related Documents, page 14-14
Standards, page 14-14
Cisco Nexus 3000 Series NX-OS Unicast Routing Configuration Guide, NX-OS Release 5.0(3)U1(1)
Verifying the Object Tracking Configuration
Purpose
Displays the object tracking information for one
or more objects.
Displays the interface-based object tracking
information.
Displays the IPv4 route-based object tracking
information.
14-13