Configuration Examples For Optimizing Pim Sparse Mode In A Large Multicast; Deployment; Optimizing Pim Sparse Mode In A Large Ip Multicast Deployment Example - Cisco Catalyst 3850 series Configuration Manual

IP Multicast Optimization: Optimizing PIM Sparse Mode in a Large IP Multicast Deployment
Command or Action
Example:
Router(config-if)# ip pim
query-interval 1
Related Topics
Optimizing PIM Sparse Mode in a Large IP Multicast Deployment Example, on page 335
Configuration Examples for Optimizing PIM Sparse Mode in a
Large Multicast Deployment

Optimizing PIM Sparse Mode in a Large IP Multicast Deployment Example

The following example shows how to:
• Set the query interval to 1 second for faster convergence.
• Configure the router to never move to the SPT but to remain on the shared tree.
• Set a limit of 10 PIM sparse mode register messages sent per second for each (S, G) routing entry.
interface ethernet 0
ip pim query-interval 1
.
.
.
!
ip pim spt-threshold infinity
ip pim register-rate-limit 10
!
Related Topics
Optimizing PIM Sparse Mode in a Large Deployment, on page 333
OL-32598-01
Configuration Examples for Optimizing PIM Sparse Mode in a Large Multicast Deployment
Purpose
• Perform this step only on redundant routers on the edge of a PIM domain.
• The default query interval is 30 seconds.
• The period argument is in seconds unless the msec keyword is specified.
• Set the query interval to a smaller number of seconds for faster convergence,
but keep in mind the trade-off between faster convergence and higher CPU
and bandwidth usage.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
335