Machine Trouble - Xerox 4110 User Manual

11 . P r ob l e m S ol v i n g

Machine Trouble

Precision components and high-voltage power supplies are used on the machine.
Never open or remove machine covers that are screwed shut unless specifically
instructed in the User Guide. A high-voltage component can cause electric shocks.
When opening the panels and covers that are screwed shut to install or detach
optional accessories, be sure to follow instructions in the respective the User Guide.
Do not try to alter the machine configuration or modify any parts. Doing so might
cause machine malfunction or fire.
Symptoms
Power is not
switched On.
Display is dark.
Unable to print,
or
unable to copy.
11 - 4
If you think some trouble is occurring on the machine, check the
machine status again.
Check
Is the power switch on the
machine turned off?
Is the power cord plugged
into the power outlet?
Is the power cord
disconnected from the
machine or the rear of the
rack?
Is power of the correct
voltage being supplied?
Is the Power Saver button
on?
Is the brightness dial set too
low?
Is a message displayed on
the Control Panel's display?
Is the printer mode Offline? Press the Machine Status button and
Is the power cord
disconnected from the
machine or the rear of the
rack?
Remedy
Turn the power switch on.
Refer to "Power on/off" on page 1-12.
Turn the power switch off and then firmly
plug in the power cord. Then turn the
power switch on.
Refer to "Power on/off" on page 1-12.
Make sure that the power supply is
200 -240 V (volts), 15 A (amperes).
Make sure that power of capacity
compatible with the specified maximum
power consumption of the machine
(2.8 - 3.1 KVA) is being supplied.
The machine is in the Power Saver mode.
Press the Power Saver button on the
Control Panel to cancel the Power Saver
mode.
Refer to "Power Saver Mode" on page 1-
14.
Use the brightness dial to adjust display
brightness.
Refer to "User Interface (UI)" on page 1-9.
Follow the instructions displayed to solve
the problem.
confirm the Printer Mode in the Machine
Status screen. If Printer Mode is Offline,
select Online in the Printer Mode screen.
Turn the power switch off and then firmly
plug in the power cord. Then turn the
power switch on.
Refer to "Power on/off" on page 1-12.
X er o x 4 5 90 / 4110 C op i e r /P r i n te r U s er G ui d e